![]() ![]() Remove one-half (1/2) inch of insulation from each wire that needs to be spliced. When splicing a wire, it is important that the correct gage be used as shown in the wiring diagrams.ġ. Connect battery and test all affected systems. Re-tape the wire harness starting at 1-1/2 inches behind theĬonnector and 2 inches past the repair. Install the connector locking wedge, if required, and reconnect the connector Splice the repair wire to the wire harness (see wire splicing procedure). Cut the repair wire to the proper length and remove one-half (1/2) inch of insulation. Select a wire from the terminal repair kit that best matches the color and gage of the wire being Follow steps for removing terminals described in Connector Replacement. Re-connect the battery and test affected systems.ġ. Make sure the diode is completely sealed from Tape the diode to the harness using electrical tape. Solder the connection together using rosin core type solder only Do not use acid core solder. Necessary, refer to the appropriate wiring diagram for current flow (Fig.ģ. ![]() Install the new diode in the harness, making sure current flow is correct. Only remove enough insulation to solder in Remove the insulation from the wires in the harness. Remove the diode from the harness, pay attention to the current flow direction.ġ. Locate the diode in the harness, and remove the protective covering.ģ. Refer to the appropriate diagnostic information.ġ. The use of a DRB III scan tool is required to configure the alarm siren module NOTE: If the alarm siren module has been replaced with a new unit, the new unit MUST beĬonfigured in the Intrusion Transceiver Module (ITM) before the Vehicle Theft Security System can Reconnect the alarm siren module wiring harness connector. Secure the alarm siren module to the frame rail. Position the alarm siren module on to the left frame rail. The alarm siren module to the left frame rail. Disconnect the alarm siren module wiring harness connector. Disconnect and isolate the battery negative cable.Ģ. Alarm Module: Service and Repair Siren Replacementġ. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |